This is the 2nd and last post on how to wrap your drum shells! Enjoy! Check out the first post here. Another important blog post to view along with this post is “How to Keep your Wrap Seams From Coming Up“.
After you have made sure there is not sanding dust on the wrap or on the shell you can apply your contact cement. If you have already drilled your holes for hardware you may want to tape the inside up so that no contact cement can run on the inside of the shell. Use a paint brush or roller brush to apply the contact cement to the shell, the back of the wrap, and the overlap! You’ll need to apply 2 coats to achieve maximum adhesion, and you can do them one right after the other. Leave no space uncovered or else you’ll have some bubbles in your wrap. Make sure you really get the overlap good! Consult the directions on your contact cement to get the best results.
Most contact cement needs about 15-30 minutes of drying time BEFORE you try to put the wrap on the shell. When the glue dries on all surfaces you may proceed. – Attention! – The glue must be dry for you to have a permanent bond, it sounds counter intuitive, but trust me, if you try to stick things together with contact cement when the cement is not completely dry, it will become un-bonded over time.
